Tag: CISCO

28 December 2020

FNC= (CISCO SPA IP Phones) – FREEPBX

Call Flow Command (Such as Night Mode) fnc=blf+sd;sub=*280@PBXIP;nme=Night Mode Speed Dial fnc=sd;ext=NumberToDial;nme=Description Block Last Caller fnc=sd;ext=*32;nme=Block Last Caller Extension with BLF and Call Pickup fnc=blf+sd+cp;sub=extention@PBXIP;ext=Extention Park in to Slot 1 fnc=blf+sd+cp;sub=71@PBXIP;ext=Park 71

19 November 2020

QUESTION – Cisco SPA525G and Call Forward functionality… | The VoIP-info Forum

All of these changes are performed on the Phone itself, and then saved into the configuration settings.Phone web portal —> Admin —> ADVANCED SETTINGSThenPhone web portal —> PHONEScroll down to PROGRAMMABLE SOFTKEYSCopy the following content into the bolded fields: PSK 1: fnc=sd;ext=*72@$PROXY;nme=Forward;ext2=*73@$PROXY;nme2=Clr Fwd; Idle Key […]

10 June 2020

SPA525G2 unable to access admin section – Cisco Community

SPA525G2 unable to access admin sectionIt sounds like this phone has been plugged into a UC5xx or a UC320 before.  It’s defaulting to it’s SCCP firmware.  If you’re wanting to use it as SIP, then you can manually change the call control settings and be […]

10 June 2020

Factory Reset – Cisco SPA Phones – Default Password

Login to phone web administration interface with your username and password. Please note, factory default login details are username: admin and password: admin Source: Factory Reset – Cisco SPA Phones – SiPalto Helpdesk

10 June 2020

SPA525G Configuration Wizard

This FREE service allows you to easily configure a Cisco SPA525G telephonefor a number of different services with known good configurations. It willwork under the following circumstances: You have a Cisco SPA525G; You must have admin-level access to the web interface of the SPA from […]

10 June 2020

Cisco SPA Deskphones with SIPGATE

 The following guide will help configure Cisco SPA phones and devices with your sipgate basic residential account.  If you’re purchasing a new IP Deskphone we recommend Gigaset, Snom and Yealink Deskphones:   What types of VoIP phones and devices can I use?  To configure your Cisco device you’ll need your SIPID and […]

10 June 2020

Configure Call Controls on the SPA525G and SPA525G2 IP Phones – Cisco

Call control is software within the IP phone that is used to supply the phone’s central functions. Changing this setting determines whether or not the phone will be using Skinny Call Control Protocol (SCCP) or Session Initial Protocol (SIP). These protocols are very similar but […]